NOTE: A damaged electronic throttle body and the removed fuel charging wiring harness must be returned to the Parts Recall Center via the usual send-in procedure. New and old level parts must NOT be used in a combination. NOTE: Due to sensitive signals the repair of the wiring harness is NOT allowed. To rectify this concern, the electronic throttle body must be removed, a new TP sensor and a new fuel charging wiring harness with both gold plated pins should be installed. P2176: Throttle Actuator Control System - Idle Position Not Learned P2119: Throttle Actuator Control Throttle Body Range/Performance P2135: Throttle/Pedal Position Sensor/Switch A / B Voltage Correlation Should a customer express concern about loss of power and that the electronic accelerator control failure message is displayed in the instrument cluster, the probable cause is a contact corrosion on both, the pins within the TP sensor and the fuel charging wiring harness electrical connector, causing the following diagnostic trouble codes (DTCs) to be stored in the Powertrain Control Module (PCM). Subject/Concern: Loss of power Electronic accelerator control failure message displayed in the instrument cluster in conjunction with diagnostic trouble codes (DTCs) P2135, P2119, P2176įiesta 2002.25 (11/2001 09/2008) Build Date:. Here is a guide to help you see what you are in for when changing the actuator out. ![]() ![]() ![]() This is usually due to a throttle actuator problem.
0 Comments
Leave a Reply. |